Save your design
Create a free account to save your config.
Choose which part to render in the 3D viewer: the deck itself, the top or bottom mold halves, or the shaper block.
Total deck length from nose to tail.
Maximum width at the widest point of the deck.
Deck material thickness.
Nose kick zone length — distance from the nose tip to the outermost truck hole.
Nose rise angle. 19° is mellow, 26° is steep.
Radius of the curve where the flat deck transitions into the nose kick. Smaller = sharper bend, larger = smoother roll-in.
Tail kick zone length — distance from the tail tip to the outermost truck hole.
Tail rise angle. 19° is mellow, 26° is steep.
Radius of the curve where the flat deck transitions into the tail kick. Smaller = sharper bend, larger = smoother roll-in.
Nose/tail tip fillet radius. 0 = sharp tip; 0.3–0.5mm matches a realistic sanded roundover.
Vertical depth from the rail down to the center of the board.
Radial: smooth arc edge to edge. Tub: flat center with arcs. Flat Tub: flat center with linear ramps.
Width of the flat center section (tub and flat-tub concaves only).
How far before the kick the concave starts fading to flat.
How much concave is carried through the kicks. 0 keeps the kicks flat. Can't exceed the concave depth.
Outer truck hole span. Industry wheelbase = this value minus the hole pattern length.
Truck hole center-to-center distance along the length.
Truck hole center-to-center distance across the width.
Deck truck hole diameter. Set to 0 to omit the holes.
Included angle of the conical screw-head recess. Common standards: 82° ANSI inch, 90° ISO metric, 100° MS24693, 120° stove bolt.
Flatten the deck underside at each truck mount so baseplates sit flush.
Bolt: two halves joined with bolts through alignment holes. Press: halves pressed together, aligned by an external tool resting on the form's end platforms.
Length of the shaped form. Must be at least as long as the deck; the press type adds alignment platforms beyond this.
Width of the raised form block that presses the veneer stack.
Diameter of the holes the bolts pass through to join the two halves. Separate from the truck holes below.
Number of bolts along the length (doubled across the width for two rows).
Diameter of the truck-mounting holes drilled through both mold halves. Set to 0 to omit the holes.
Height of the solid shaper block, with the deck's male contour carved on top.
Diameter of the truck-mounting holes drilled through the shaper block. Set to 0 to omit the holes.
STL (mesh)
Cleaner-looking preview. Slower to render.
Persp
Ortho
Reset view
Top view
Bottom view
Side view
Front view
Rendering model…